Search results

Mine as well

Exactly

You are 100% correct. But this isn't a pressure vessel, and the seals will be designed as such. It's a gearbox with an open breather tube.

Heating and cooling cycles requires airflow in and out, breathing. 😜 If you only let air out with a one way valve, air will find other ways in under vacuum, such as bearing oil seals, gaskets etc. Other substances such as dirt and water can follow the air breathing if you don't control where...

The issue with this is you want it to breathe (in and out) but avoid water ingress. A gore vent would be perfect for this.

I'm sure they planned for future models with 12V needs, it would be short sighted not too. I still haven't had a chance to install everything yet but I believe these are the correct pins. When I ordered they didn't have cut singles available but they do now. I'll have about 98 spares if...

Yes, agreed

Yeah I agree. While a live data connection can certainly enable nefarious behavior, I highly doubt that's the case at the moment. They took a page right out of the Tesla playbook by having cellular and WiFi connected bikes which allows for simplicity and reliability in firmware/software updates...

I don't have much prepared right now to share but I can tell you if you look at the back of the VCU plug, you will see a number of rubber/silicone plugs blocking off unused terminals. A number of them appear to be a small gauge and likely signal connections grouped on one side, but there are...

Unlikely but possible. Without knowing more details about the architecture and associated safeguards we really can't do more than speculate.

New and never used Stark 21/18 power tubes. $50 shipped. These are new replacements from Stark that just arrived a few days ago. I decided to use traditional heavy duty tubes since it suits my woods and trail riding better than ultra lightweight.

Thanks for posting this. One thing to note is your gasket looks pinched and not in the channel on the right side. It looks like an assembly defect. I'd get some RTV on there before re assembling. I want to open mine up now to check the gasket integrity....especially since I've already had my...

Looks good! Also, FYI there is 12v available on the bike without cutting into the factory harness if you need it. I'm in the process of getting all of my street legal gear set up. I'm going to be running a motogadget for all the low voltage control and switching etc.

How far do you need to go, what temps will you be riding in, and are you sure electric is the right type of bike for this?

Yea that makes sense, I'm just over 3100 and I have a 2024. Paid in full the last week or two of 2023.

31XX here, picked mine up in mid February

The only two variables I can really think of are sales tax and dealer doc fees. I considered ordering mine to a dealership in New Hampshire to avoid sales tax, but since I was planning road and off-road registering in Massachusetts I wouldn't be able to avoid the sales tax either way.

I don't know if Geico insures motorcycles in Canada but it was no problem when I street registered my varg last month. I just have the basic level of insurance at the moment but there was no issues covering it fully for theft, liability, and collision if I wanted to. The bare minimum liability...

I could probably use a short seat 😂

I hope so. We should be able to set the maximum charge % as well as scheduled charging where you can set a time to be at a certain %. I'm sure we will see some of these features in time.