Anders

I'm already planning something. I'll let you know how it turns out tomorrow.

That too bad. But his idea for mounting the link guard above the skid plate could be an idea to copy, if you feel that your solution...

I applaud DIY solutions. However, Dowatek is actually selling something like this...

I got tired of waiting for someone to sell a linkage guard/skid plate, so I made my own from a very thin (3.5mm-4mm) high density...

For what it's worth... I have so far only ridden my Varg for EX 5-6 hours in winter conditions with snow. Some of it quite loose snow /...

The warranty period can be prolonged 2 extra years for $999 according to Sam. If the spec of the demo bike is the same as you prefer, I...

I think Mefo also has mousses for particular tire types and sizes.

I've been wanting to build this since before starting on Svag, but it made more sense to get a better understanding of the BLE interface...

I went for the Bulletproof Designs one. It is an adapter that accepts KTM plastic blocks. For the plastic, I chose the BRP. On my petrol...

I angled my light down as much as possible, then I even ended up taping over the top half of the light. The best solution is probably...

All 1-1/4" handlebars have taper from 7/8" diameter where the grips and controls are, but they will still clamp OK. I didn't modify...

I think those are the champs I have available. However, when I tested them briefly, it seemed like the handlebar was tapering off to a...

I'm using the standard Cycra 1-1/8" clamps on the handlebars. You always have to do some minor tweaking of the aluminum handguard bar to...

When riding enduro in the dark, I try to stand up as much as possible. When standing in "attack mode", my eyes are ahead of the...

Regarding the Cycra Probend hand guards: What type of bracket do you use at the inner ends? And what model of ASV levers did you choose...