Recent content by Bloak

PM sent

For sale: Two 2018 Alta MXR's 215hrs/5082kmn (vin0436) 104hrs/3776km (vin0373) Both have code 36 batteries (most likely broken wire bond). Both work fine as they are and still get occasional use. Suspension is Race Tech for 190lbs, intermediate MX. Rear shock has been converted to bladder...

Another solution, attached drawing for chain slider bolt bolt diameter of 14mm worked well on one bike and other needed to be slightly smaller 13.87mm....best to take measurement of old bolt for diameter prior to making I've been using KTM # 79003053010 chain Sliding Kit Below Cpl.16 (also KTM...

Mine has been pushed from Dec 2023 to March 2024 I'm ok with the delay, as it gives me more time to procrastinate if I need a new bike.... although new is nice, having difficulty justifying a new bike when the Alta does everything I need.

From eBay, I bought a clutch master cylinder and perch assembly from a 17-19 KTM350 EXC. Also found an Alta LHRB line on eBay. Works good. Works same as the stock Alta LHRB.

For those using the 3D printed repair, how is it holding up?

Hopefully they don't use a page from Harley Davidson playbook.....

I don’t have a picture readily handy of my bike. They look like standard handle bars. I you looked at my bike, you would assume they are ProTapers. Twisted Engineering | Good write up from @Phillip regarding the Fasst Flexx bars. I used them on a RMZ and eventually went back to standard bars on...

I've used fasst bars and they felt "heavy". Been using twisted engineering bars for years now It's another option when looking for bars that flex

I've had a charge issue which was intermittent....ended up being a wire was loose within outlet

Clutch for whiskey throttle situations would be handy .....

I went with steadystand for my boxvan. Work well, no complaints. My setup places first bike in backwards and second bike in forwards. This allows the bikes to be closer together for more room (generator, power washer, and the other stuff I probably don’t need to lug around)

Not mine, https://www.kijiji.ca/v-dirt-bikes-motocross/oakville-halton-region/alta-mxr-redshift/1578607035

I've changed silica packets without complete battery removal. In or out, that butyl is a pain to clean off.

That's it. I have one on the way. Thanks