Recent content by Brad 594

@Altabosch, like Rashid510 indicated, it is the butyl rubber that is necessary to create a seal between the black bottom cover and the lower battery casting. I would not recommend trying to "clean it off" or remove the oozing black butyl. You don't want to compromise the seal that is protecting...

Fun times! Looks great Chris!

The sale of the bike is pending. I'm not interested in any trades at this time. Thanks.

Hi Sam. The battery connector is located inside the ACM box. Once you remove the Delta wing, you will need to remove the screws that are holding the ACM. Once the ACM is loose, you will be able to adjust its placement just enough so that you can access the battery compartment to change the...

Selling my 2019 Alta Redshift MXR Well cared for and a blast to ride Battery charge kept at 50% when not ridden Runs well and charges great - No error codes - 696 miles - 54.3 hours - Updated 2020 CRF front fender and number plate - Left Hand Brembo rear hand brake added - SKDA seat cover (with...

https://electricdirtriders.com/threads/service-9-volt-starter-battery.863/ Check out this link for help.

Last April, my 2018 MXR had intermitted black screen dead (no sound or noise from bike) when key was turned to On position. I suspected the 9 Volt to be the culprit. I successfully replaced the 9 volt battery and that solved the problem and it has not happened since. I had read many posts that...

I am looking to clear a Code 37 (humidity code) on my 2018 Alta MXR after replacing the desiccant located under lower battery cover. Is there anyone in the Houston area that has a laptop to help me clear this code from my bike? I would also be interested in purchase of laptop if someone is...

Selling my 2018 Alta Redshift MXR - 876 miles - 62 hours - Left Hand Brembo rear hand brake added - SKDA seat cover - STR fork bleeders - DID ERT3 gold chain - Hot Foot Moto front chain slider - Supersprox rear sprocket (52T) - Dunlop MX33 front tire - Dunlop MX12 rear tire - Fast Charger -...

Welcome to the forum!

For the past few months, my 2018 MXR has been intermitted black screen dead (no sound or noise from bike) when key is turned to On position. I suspected the 9 Volt to be the culprit. I successfully replaced the 9 volt battery last night and it has appeared to solve the key On problem. I have...

I use a Q6500 Quiet Power Briggs & Stratton generator at the track to charge my MXR. It is works very well and is relatively small and very portable with wheels. I use a Rapid Charger at the track. The Standard Charger was too slow for track use in my opinion...

I run a Supersprox on the rear of my 2018 MXR. I have used these rear sprockets on my other 450 bikes. The outer steel teeth on the Supersprox wear much less than the aluminum rear sprockets that are also available. You will need to order the Supersprox to fit KTM/HSQ. The biggest Supersprox...

This what I use for my MXR. I became very tired of lifting MX bikes onto their stands over the years. This stand is so easy to lift with one foot operation that required very little effort. Stand quality is excellent. Bike is very stable on the stand. Packs well in the back of my truck when...

PM Sent