Dave Daum's latest activity

I just ordered the parts. Thanks guys!

Soldering is probably the better route. The screw type damage the cable which could lead to a failure. The soldered joint will not and...

so I finally got around to finish up my "E-Clutch" Lever :) Basically the same @HadesOmega you did but with some different parts. here...

Cool yeah I can't believe soldering the end worked so far it's been through a handful of races no problems. I am going to build one...

To build this regen hand brake you will need: 3-pin HIGO connector https://amzn.to/4jyIP5B Pitbike Clutch Lever Assembly (Black)...

Hi Hades, thanks for sharing this. Was funny seeing you Soldering that Cableend xD I was standing on a similar Problem some time ago...

Attached is an image showing the screen were you can find the hall sensor calibration. Please let me know if the recalibration helped???

I was having similar problems. I did a Hall sensor recalibration and it fixed everything. Did you try recalibration of the Hall sensor...

Mine runs pretty good now but it has a back EMF problem that I had to tune out. At high RPM and high speed when you close the throttle...

Same experience with Charged Cycles. No replies to emails.

Yeah I've watched almost all your videos. I had already decided to do an electric conversion before I came across your channel, I've...

I built on the same chassis. Don helped a lot and I’m real satisfied with the end result. I went for a 96 volt system with a FarDriver...

I am glad I helped you get interested in building an electric dirt bike. You look very thorough in your plans. You look like you want...

New to the site, found it by reading the comments on Don Cox's youtube videos. I raced motocross for several years in my teens and 20's...

I'm not sure about the EBMX X-9000 V3. The size is the greatest challenge in my opinion. The V2 is an amazing control. I've used the V2...