Dave Daum's latest activity

You can adjust how strong you want the regen in the app. I find for going down long hills its actually too much regen. The bike slows...

Could you please describe the effect of full re-gen pull of the lever on the rear wheel and engine? Particularly on the steep, long...

you don't need to get the full travel out of it, as long as you calibrate it for the way it works currently.

@HadesOmega and @fmxxx666 you guys inspired me to jump all over the regen brake lever. I took one of the old CRF450 throttle cables and...

Cool. I just use it in a race this weekend and its great for backing it into the corners in the dirt.

how do you recalibrate the hall sensor? Was it a physical adjustment of the sensor itself? Or a learning procedure in the controller?

I contacted EBMX first (bought from TB), but EBMX told me to contact Charged since I live in USA. I’ll try again (and am watching at...

Hi, I wanted a V2 watercooling heatsink a little over half a year ago from EBMX they also sent me to Charged cycleworks but those idiots...

I just ordered the parts. Thanks guys!

Soldering is probably the better route. The screw type damage the cable which could lead to a failure. The soldered joint will not and...

so I finally got around to finish up my "E-Clutch" Lever :) Basically the same @HadesOmega you did but with some different parts. here...

Cool yeah I can't believe soldering the end worked so far it's been through a handful of races no problems. I am going to build one...

To build this regen hand brake you will need: 3-pin HIGO connector https://amzn.to/4jyIP5B Pitbike Clutch Lever Assembly (Black)...

Hi Hades, thanks for sharing this. Was funny seeing you Soldering that Cableend xD I was standing on a similar Problem some time ago...

Attached is an image showing the screen were you can find the hall sensor calibration. Please let me know if the recalibration helped???