Recent content by svtride

Interesting, I just asked Sam if the Red diagnostic connector harness came standard with US models, and was told it does not.. Sam horn kit VIN cut-in info: I’m also due the phone rubber surround.

No. I disassembled the water pump connector (removed terminals from plastic housing) and spliced into existing leads, heat shrunk splice then reassembled connector. Harness I built was just a 2 amp fused +/- circuit up to handlebar to the powered GPS mount. I see Stark has a pigtail for the...

I did not receive this dongle with my US EX Stark. Is it a later VIN possible? I also did not receive a horn which Stark is now sending me.

I just asked SAM..seems its VIN specific…my VIN is applicable so I’ll request a kit..thanks

Hand bicycle pump Interesting Bosch pump. 0.45kg, $110 US…Christmas is coming

Pls explain to me the Horn Kit? Only horn I got with mine from dealre as U.S. model is in the phone...

In my 13 liter backpack, I carry basic tools applicable to bikes I ride, 21”std tube (can be used in both frt or rear tire), AL tire spoons, mini bike air pump, tow strap, master link, first aid kit, hydro pack, bunch of misc fastener bits..safety wire, duct tape, mini DMM, fuses, etc...

Yes, case remains open whilst charging. I travel to different ride areas in my state with my bikes and gear, so I’ll need to take the charger with me, wherever the Varg goes. The case, I find, is a good balance of weight, portability, travel protection. The stand Stark delivered with the...

👍 If I did something that simple, I’d for sure damage it, something drop on it, run it over or fall off the tailgate of my truck. Pelican case at least gives some protection from my stupidity.

Thanks Michael for the OBDII connector tip. This lead me to strip the plastics off my EX (purchased via dealer) for the first time and I was able to find the round HIGO OBDII . I did not receive an adapter cable with bike at purchase. [I know now what it looks like having Googled it. The one...

First off, I have no direct experience with Higo connectors/cabling and am looking for advice from the collective here on sourcing and/or self-fabricating (if even possible as they are over-molded) cable assembles. That said, this is what I am conceptualizing: In looking for a solution for my...

My adaptation to right sizing charger assembly..in keeping with the KTM motif

Very common to balance in my group... - 5-10 minute per wheel extra effort when the the majority of work is taking wheel / tire on and off - when connecting trails on a ride loop, we sometimes have a mile or so of asphalt between with speeds up to 60+ mph - Hooning - flat tracking it through the...

I preemptively replaced my tubes this week on my EX. I don’t trust them. The rear tube had a rubber flap/doubler over where the rimlock would contact tube. I noticed too that when I went to remove the Schrader valve core the entire metallic portion of Schrader valve spun in the red tube...

I never read that all US bound Stark bikes would get free LHRB only if you ordered that option. I may have missed that memo. But I ordered the bike specific with the LHRB option at time of order as it was a legitimate listed option along with tire and tube types, weight specific springing...