Front sprocket not centered after install (Stark Varg EX) — normal or issue?

[Julo EX]

Hey guys,
I swapped the stock 12T front sprocket on my Stark Varg EX for a 14T. The install went smoothly — everything seemed fine, no weird noises or chain issues. I did a short test ride and it felt perfect.

But the next day, when I looked closely, I noticed the sprocket doesn’t sit exactly in the middle — it’s slightly offset.

Is that normal when upgrading to a bigger sprocket, or should I take it off and reinstall it perfectly centered?

Thanks in advance for any advice!

 

[Julo EX]

 

[Julo EX]

some more images

 

[Bodo]

From the pictures, it's only visible that the washer is significantly off centre. Is it the correct one? When the inner bore of the washer is too big, it could move out of centre just like it does in the pictures.

It should be mechanically impossible to not center the sprocket on the shaft:

 

[Julo EX]

From the pictures, it's only visible that the washer is significantly off centre. Is it the correct one? When the inner bore of the washer is too big, it could move out of centre just like it does in the pictures.

It should be mechanically impossible to not center the sprocket on the shaft:
View attachment 15059

I used the same washer, is there another Washer for bigger sprocket? Should I remove it and try to have It really centered?