fmxxx666

after I failed to buy from Charged Cycle Works I got in touch with "Damon Jackson" Business Development Manager at EBMX E-Mail...

the 165 they list is the 30h/35h that LBX's use. It's half the size, and no reduction gears. Which I'm sure also has the same hall...

The QS138 harness will work for I guess any QS mid drive motor as they all have the same connector of the hall sensor and the same pin...

Hi, I wanted a V2 watercooling heatsink a little over half a year ago from EBMX they also sent me to Charged cycleworks but those idiots...

Little test of my new Insta360 setup Mounted on the chest finally after a week of patience I got my Suspension back Full Service...

So I was quiet for some moths xD but but here a little update: I have now roughly 32 Hours on my build. Zero Trails just MX Track. and...

Hello Mr. D_Daly, welcome to the Forum. Yes your bike works perfectly for this type of build. Go to post #11 in the article, (Your...

The X-9000 thumb brake is simply awesome. The thumb brake has so much strength I can easily skid the rear wheel.

@Dave Daum in case you ever wanna add watercooling let me know, I have a Water Cooling Heatsink for the EBMX X9000 lying around. Had...

Thus far I love the X-9000. And, I love the thumb regen lever. It is stronger than the rear foot brake. I can skid the rear tire on...

you´re welcone, congrats nice work that turned into another awesome bike 👍 how do you like the EBMX thumb throttle? have you set it up...

Here is a short video of the first ride on my just powered-up 2020 CRF 450. Thank you @DonCox and @fmxxx666 for your tips and...

All the brackets are welded, the master switch is installed and I just have some minor wiring to do. I’m getting excited to power it up!

Yesterday I finished the last of everything except wiring the master battery disconnect and resistor. I just need to create a break in...

oh forgot to explain this one: Both values need to be correct otherwise your speedometer won´t tell the truth wheel Diameter in...