VINSANITY

I separated the sensor wires from the phase wires like Helienduro mentioned above, it made a big improvement but didn’t totally solve...

I have this index finger trigger throttle for regen set up on my conversion bike with an EBMX X9000 controller. It’s great when street...

I have the same controller and the same studdering problem - it happens in a hole shot situation every time - full acceleration with...

I will check out dirt tricks, Amazon / ebay didn’t have smaller ones

Common rear sprockets are 48-51 tooth - smaller rear sprockets are surprisingly uncommon - also changing gearing with front sprocket is...

Thanks for helping out with this - I think I will contact JT sprockets to see if they can find a compatable sprocket - I street ride 50%...

I asked Derek if he could get a 15T sprocket, he didn’t think there would be enough demand, basically said no.

Interesting - I have a 96volt build with the QS138 motor - my current gearing is 14:46 and it still over revs at mid throttle (which...

One more thing, just visual observation but you motor sprocket appears to high relative to the swingarm pivot - do you have a way to...

Where did you get the 15T front sprocket and is it 520 chain. Also nice work

I had a lot of set up problems with the FarDriver ND961000 where it would intermittently cut out - if you are going 96 volt recommend...

My experience is you have to ride one of these conversions to really understand how well they perform, low center of gravity, super low...

Interesting build - what is your battery specs - also how does the hub motor perform, top speed and is capable of off road

For the Honda frame I would be curious if this shape at 9.5 inches wide would be more capacity than what you are proposing. If you...

That’s very clean, had a real close call on range recently so this is a potential solution. Can you share the outside dimensions and do...