Recent content by Jasperfield

That is a nice bike,I really like the seat, It just sets it off!

This outfit doesn't have any money, and you'd be crazy to lend them your bike. Tell 'em to get lost and hang onto your bike in good shape.

In a practical sense, what does that give us? What would be the difference that we would notice between an EX converted to 17" vs. the new SM bike?

wfopete, I'd love to have your original bracket, it works perfectly when converting any model stark to supermoto. Would you be interested in mailing it to me? Thanks, Jasperfield

I'm curious if the new supermoto model will have some SM specifics other than tires and a suspension tuneup.

Measure your screws very carefully including the thread. Then go to the McMaster-Carr website and begin looking at screws. I am certain they will have your screws, but it may take quite a bit of looking through their selection. You can also buy spacers from them.

I really like my stock tail light, they did a good job in integrating that light as a small unobtrusive fixture. I would like to see it quite a bit brighter, but until that happens I'm really happy with it.

All versions of the side stand bracket have the same number, even after the new brackets were put into service.

Buy an early version stark kickstand bracket and use that bracket on your EX. This will solve the kickstand problem if you're using SM wheels. I have 17 inch wheels on my EX and use the early version kickstand bracket with the current EX kickstand. When stark changed the bracket and begin using...

I would really like to try it, but don't want to sacrifice my left-hand rear brake control.

Try using a nutsert or a rivnut of the appropriate size. These are used extensively in aircraft and can be purchased from Aircraft Spruce in the U.S. or Europe.

My sn. is 270 and it came with the plug, rubber phone shield, but no horn

Rather than try to extend your kickstand or modify your bracket, get the new bracket that is being shipped with the Varg EX. That bracket will lower the mounting position of the kickstand thereby increasing its length. And, it works very well. Yes, the "ring" around the kickstand bushing is to...

See if the bolts that attach the bracket are too long. If so either shorten them or use shorter bolts.

Is the charger that comes with the new EX the same as the charger comes with the MX bikes. I have both bikes and both chargers, and it cannot tell that there is a difference between the chargers. If this is the case I should be able to charge either bike with either charger. If any of you have...