HANDGUARDS

[FreedomFlyer]

I tried buying the new EX Handguards on Stark's website to no avail. Here is my email to them:
Hello how do I buy the EX handguards?
The way you guys designed the original I can't find any handuards that will fit right due to lack of space to mount them to the handle bars. Tired of getting my hands beat up and wasting money on handguards that don't fit.
Thanks,
Josh

 

[Dirt-E]

I was considering bark busters for mine. But wasn't sure how to modify the bar ends to put in the tip bolts. I put them on my Alta, so I would assume it's nearly the same. Haven't had the gumption to go tearing into the new bike (Stark) just yet.

I do like the idea of the Enduro guards, even if they not full wrap. My son likes his guards on the TX300, but they tend to rip the screws out when he hits stuff. So far, we've been able to just put the screws back in and it holds the plate.

 

[FYR]

I tried buying the new EX Handguards on Stark's website to no avail. Here is my email to them:
Hello how do I buy the EX handguards?
The way you guys designed the original I can't find any handuards that will fit right due to lack of space to mount them to the handle bars. Tired of getting my hands beat up and wasting money on handguards that don't fit.
Thanks,
Josh

My bars are stock width and these fit well. If you're looking for full wind or roost protection, then they're not going to be the best choice. But they do have a a full aluminum wrap co-molded inside the plastic and mount very solidly.