Geci
Active member
- Likes
- 33
- Location
- Ontario, Canada
I ended up remaking the front chain slider using measurements from the one off my bike. I also have a 3d printer at home so I'll be printing the first version soon. 
Lower Front Chain Slider
- Thread starter Geci
- Start date
Bloak
Well-known member
- Likes
- 134
- Location
- Ontario, Canada
3D print with ABS filament?
Trialsman
Well-known member
- Likes
- 601
- Location
- Pittsburgh
You can also turn it into a chain tensioner by the addition of a spring that pushes upwards against the frame. A hole in the center upright can contain the coil spring.
Geci
Active member
- Likes
- 33
- Location
- Ontario, Canada
Yes, that's all I have at home right now.
Geci
Active member
- Likes
- 33
- Location
- Ontario, Canada
Good idea but extra wear might be an issues.
privateer703
AOF Addict
- Likes
- 687
- Location
- Altoona, PA
Make a space to bolt on a small UHMW pad if you want it to be a tensioner.
Geci
Active member
- Likes
- 33
- Location
- Ontario, Canada
Here is a comparison picture of the draft print and the original part.
Trialsman
Well-known member
- Likes
- 601
- Location
- Pittsburgh
3-D printing gives you a great design advantage. You could mock up another modifying it to have a vertical pad to drill and mount a roller for the chain to pass over. You could also beef up the vertical support to house a coil spring for tension against the frame tube. Remaking the part may be necessary but making it better might be a possibility. My dad would always ask me,"Can't you leave anything alone?"
Geci
Active member
- Likes
- 33
- Location
- Ontario, Canada
If the abs wont last long enough, I'll definitely rig up a roller style setup. Sadly its snowing here now so this has to wait.
- Likes
- 2,479
- Location
- Charlotte, NC
Really good stuff. Did not realize another person was 3d printing parts. Did you ever get around to testing the printed slider out, or have you made any further progress?
