Please Help! KTM Freeride exc Brake Light

[ryanmx48]

any body know how tomorrow convert the stock taillight too also works as a brakelight? Haven’t uses hydraulic pressures switches in the past but can’t find anything. Mine is a 2022 if that matters.

Thanks

 

[Gtrbo1]

Just a heads up I have 4- 2021 Freeride E’s and mine all came with brake light, high beam and a horn. where did yours come from. Mine were PA.

 

[smdub]

Mine is a 2020. Also has a working brake light from the factory. The little switches are activated by the inner tips of the brake levers. They are not tied into the hydraulics.

 

[standbyu]

any body know how tomorrow convert the stock taillight too also works as a brakelight? Haven’t uses hydraulic pressures switches in the past but can’t find anything. Mine is a 2022 if that matters.

Thanks

M10x1.25mm For EXF Brembo Hydraulic Brake Pressure Light Switch Banjo Bolt Black | eBay

Thread Size: M10x1.25mm. 1x Hydraulic Brake Switch Cable 2x Gasket. Use for Hydraulic Brake system. Color: Black+Silver. E-checks will be held until cleared. Easy to install. Cable Length: 250mm (approx).

www.ebay.com

some are 1 pitch

 

[RJS]

Mine also had the brake light. What mine did not have was the lower part of the switch gear that incorporates the turn signal selector, and the wiring harness did not have provision for turn signals.

 

[undertheoaks]

Stock should have them mounted to both brake levers, they are pressure switches, meaning evey time you pull the lever it toggles the switch on. They just snap on, I used silicone to make sure they don't fall off when riding. Of you look under the lever there are two small holes where the switch is mounted.