Redshift charging connector type

[AnthonyZ]

Can't find the answer to this on here, so sorry if this is a repeat question.
What connector type is the charging port on the E/MXR?
Is it proprietary?
Is there a source?
Anyone happen to have a wiring diagram?

 

[AnthonyZ]

Seems like Souriau UTL line connector.
Part# 102G1W3 maybe?
Not sure about the 120 Ohm resistor, I'll measure when I get a chance.

 

[Rashid510]

Seems like Souriau UTL line connector.
Part# 102G1W3 maybe?
Not sure about the 120 Ohm resistor, I'll measure when I get a chance.

Theres no 120Ohm resistor..but the PN is close. Do you need a harness? Or the opposing end?

 

[AnthonyZ]

Theres no 120Ohm resistor..but the PN is close. Do you need a harness? Or the opposing end?

I'll eventually need a cable with the female (charger) side for a project I'm working on.
No urgent need, able to charge the bike and everything at the moment.
Thanks for the tip on the resistor. The CAN terminating resistor is at the factory charger?

 

[AnthonyZ]

Souriau
102G1W3 Layout, shell size 10, 3x#16 + 3x#20

See catalog page 26-29

https://www.mouser.com/pdfDocs/Catalog_UTL_Series_US_version_-2.pdf

These filters on mouser give the relevant material

https://www.mouser.com/c/connectors/circular-connectors/standard-circular-connectors/standard-circular-connector/?m=Souriau&number%20of%20positions=6%20Position&series=UTL&shell%20size=10

I'll buy some and report here if I got it right.

 

[AnthonyZ]

Mechanically fits

 

[EDR1]

I measure 120 ohms (CAN terminator) across 2 of the small pins for both the shell-size-12 Varg (pins D & E) and the shell-size-10 Alta (pins C & B) - while they are both wired to the Elcon, therefore not sure if there is a resistor inside the Souriau plug or on the Elcon PCB (technically, this termination should be at the extreme ends of the source and loads)