Where is the flasher ?

[Trialsman]

I have two EXRs and just replaced the turn signals on the one. They are barely flashing, probably due to the ones I took off were LED and the new ones are not. I assume the flasher needs switched over, but where is it? Thanks for the help.

 

[Rashid510]

I have two EXRs and just replaced the turn signals on the one. They are barely flashing, probably due to the ones I took off were LED and the new ones are not. I assume the flasher needs switched over, but where is it? Thanks for the help.

There is no flasher/relay in the Alta harness, its managed by the ACM. If your going to use LEDs you have to add a resistor inline to slow them down.

 

[Trialsman]

Thanks Rashid510, I had LEDs with the resistors and removed both to put on some incandescent ones I had in the drawer. Now the dsh light flashes quickly and the bulbs barely light up and are a quick cadence. Any ideas?

 

[HadesOmega]

Hmm New Rage Cycles selling a blinker kit for the front of the redshift and according to their instructions you need a 22ohm resistor

Alta Redshift Front Turn Signal instructions - New Rage Cycles

Alta Redshift Front Turn Signal Installation instructions 1) Remove stock screws to take off stock blinkers (picture 1) 2) Unplug stock connector(s) 3) Take NRC blinker and unscrew lower lens bracket; use stock bolt and mount onto bike (picture 2) 4) Screw lens back onto lower bracket (picture...

newragecycles.com