Search results

Sad way to start a new year when you know that it’s the last day I will be battling with my Alta buddy.

Our local state track is getting with the times. I think they forgot my name on the parking spot.

Making the Alta 300 + lbs with a nicely groomed track.

Just received this from a friend need to have our “brains” of this form check it out ? Electric Motorcycle, Electric Motorbike, Motorcycle Conversion Kit, Electric motorcross, DIY Electric Motorcycle, GMX motorcycle

Sounds like you would have a more enjoyable ride if you just sold the wife and kept the Alta.

Check your primary gear bolt for proper torque. Here a video with primary gear noise when gear is loose. primary gear Noise after proper torque.

Nicely done very entertaining. A lot of talent and trust.

Check your cradle bolts.

Do I qualify for my own roost gallery if the particles come off my own bike? These particles came off my rear tire under breaking for a corner And hit me 😂😂😂

That’s because you’re leaving all the corrosion in the battery when you drain the electricity up.

Cleaning the charge ⚡️ Removes the corrosion to make more surface on the battery plates and makes lighter electricity ⚡️

All the bolts and screws In there had white marking. That’s good now I don’t have to go looking for the Assembler that was the white marker. 😂😂😂 That person did his or her Job. 👍

I noticed there is no paint mark on the bolt or the sprocket....are there remnants of one? Small amount of mark left.

This should answer you question. you might have to run it in map 3 after the first lap on hot days. A Guide to Thermal Limiting

I think in forward motion the spline on the gears stay tight and when rolling backwards they separate causing the binding (Locking up). Question for @Rashid510 Do you think the bolt could of came loose from hammering motos in map one? @Fod and I have been doing Motos together in map one at the...

Thanks of the information @Rashid510 I was concerned about the gear being loose and oil getting in to the motor through the bearing. I’m going to replace the bolt since The first couple of threads are worn off is there any thing special about the bolt? The gasket still looks good so I’ll try to...

Check your reduction gear.

The motor primary bolt blackout. luckily I caught it before to much damage on case My question now is does the gear have to be press on over the taper part of the Motor shaft And what’s the torque for the bolt. Do the gears line up evenly? The bearing on the motor is a wet bearing? Looks like...

Just checking if anyone has had there bike locked up? Was rolling it backwards into the garage in the motor locked up. Pop the chain off and the countershaft sprocket is tight spinning in both directions. Curious if anybody has had a problem or where I should begin looking? The good thing is...

I talked to our good friend up there today and he told me that we were approved for use of electrical outlets by the previous administrators. A year ago they even approved the installation of a larger transformer to bump the voltage from 208 to 240v. The new state rangers are on a little power...