SandlotOffRoad
New member
- Likes
- 1
- Location
- Punta Gorda, Florida
Does anyone have some spare gaskets for the timing cover and gear covers?
Want to buy Timing cover and gear cover gaskets
- Thread starter SandlotOffRoad
- Start date
Trialsman
Well-known member
- Likes
- 600
- Location
- Pittsburgh
All you have to do is get gasket material at NAPA and trace the cover on it. Cut it out, punch the holes, put sealer on one side and bolt it back together. I have done it on two EXRs now. It's very cheap and doesn't take long to do.
- Likes
- 1,171
- Location
- South San Francisco, CA
You dont need the timing cover gasket (unless the previous owner broke it). The gear cover gasket I do have. Or you can get gasket material.
FrancoLizard
Active member
- Likes
- 27
- Location
- North Texas
Is there a specific type of gasket material that would work best for the gear cover?
- Likes
- 1,171
- Location
- South San Francisco, CA
I believe its similar to fel-pro gasket material. I will try to find the spec on it. Also fyi I do have gaskets available.
FrancoLizard
Active member
- Likes
- 27
- Location
- North Texas
Thank you @Rashid510 . I have a laser cutter, so I thought it might be a fun experiment to make some gaskets. This assumes that the material is laser-friendly (won't kill me with chlorine gas). If it's not laser friendly, I'll reach out for some gaskets. I appreciate the help.
- Likes
- 1,171
- Location
- South San Francisco, CA
No problem. Its MP-2N Gasket Material - MP-2N Gasket Material | Custom Die Cutting for MP-2N.'
Which is usually diecut. You might be able to try laser depending on the heat output.