Search results

Sadly not built into the VCU which just gives the calibrated speed (in kmh and using their static drive-ratio) and the motor RPM.

The app doesn't behave any differently from the VCU perspective compared to the stock version. Stark's terms are pretty broad but at least in the US reverse engineering cannot be restricted. I imagine in the EU there are similar standards for allowing users control over devices they own. As to...

I briefly shared some details on this in a thread about extracting soc data but I've built an alternative app to the stock Stark one. This app runs on both iOS and Android while supporting most of the stock app features except "writing" configuration data like maps, charge rate, and other bike...

It's a terrible switch. You have to press it with minimal force and at a weird angle instead of directly left or right, and even then it has very minimal feedback with gloves on so you have to visually confirm. On mine trying to indicate left will hit the right indicator instead about 20% of the...

I have 2,795 miles on mine, I got the 1.2.8 firmware patch about two weeks ago (I can't quite remember, but maybe a bit longer?). That odometer is about 5% over at this point based on my wheel and gearing changes, so probably closer to 2600. As an aside, always make sure to use the ODO on the...

Thanks, was relatively easy to reverse engineer the Stark EX App and go from there. The units in that older version are a bit all over the place (was still figuring out whats what), the fan/pump amperage is off by 100 there. Main thing the motor sensors give are temps and current for ID/IQ...

For the EX it's possible, I believe the MX should be similar but I don't have one (or access to the app for it) so I can't say! For the EX you just need to pair with the per-vin pin code and then (in BLE terms) subscribe to notifications for the characteristics you want to read. If you just try...

Ah weird, I would have preferred to just upload the 3mf/iges files themselves but the forum only allows a few file types. I uploaded the 3mf (https://www.dropbox.com/scl/fi/l4555i0urtbq31qon22l6/explatetidy.3mf?rlkey=3gomrk7eqwpijnuhyrtagnhkn&st=xeizzumr&dl=1) (should be ready for 3d...

Whipped this up because I wanted something slim (and simple) for the plate mount. Attaches to the tail section via some semi-low-profile bolts in the three holes. It should fit most US motorcycle plates, I have no clue about anywhere else.