lights

[73Thing]

Whats it going to take to run a headlight on the Stark? And anyone with picks of aftermarket bars and hand guards?

 

[erSitzt]

I have Circuit hand guards, they fit okay (with rear brake on the handlebar).
I tried Acerbis too, but they fit a little less good..

Difference between the two variants, Circuit mount goes below, Acerbis on top.. i can post a photo later if you like

 

[erSitzt]

These are the Circuit Handguards

 

[73Thing]

These are the Circuit Handguards

View attachment 10609

View attachment 10610

View attachment 10611

Good info and looks good from here. Thanks erSitzt

 

[Aleksandar13]

Q

These are the Circuit Handguards

View attachment 10609

View attachment 10610

View attachment 10611These look a lot better than my Acerbis... Might consider them

 

[LTJ]

Tusk hand guards work great also.

 

[Raindog]

 

[Raindog]

The tail light is Magicshine SeeMee300 with a motion sensor that throws a brake light when it senses deceleration, perfect for regin. The headlight is a Magicshine Monteer 8000S, brighter than the sun but infinitely adjustable through the bar mounted switch.

I have the battery for the headlight mounted on the frame, the tail light is a self contained unit.

 

[Bernardo]

The oem light from the EX dazzle other driver on the road.
they are set to high
Any ideas?
It cant be adjusted i think.

 

[DaveAusNor]

It cant be adjusted i think.

There is a single screw which looked to me that it might adjust the level of the beam (i'm not 100% convinced it does or doesn't do this). I turned it a lot in both directions, in the end I found the top of the light beam on my garage wall had reduced by a minor amount, maybe 10cm or so.

 

[Bernardo]

thanx and yes.
there is an adjustment screw at the lower end of the electronic part of the headlight.
it can be seen when dismounted.
a plastic one. the whole inner part, reflector included, move up and down.