Search results

Another solution, attached drawing for chain slider bolt bolt diameter of 14mm worked well on one bike and other needed to be slightly smaller 13.87mm....best to take measurement of old bolt for diameter prior to making I've been using KTM # 79003053010 chain Sliding Kit Below Cpl.16 (also KTM...

Mine has been pushed from Dec 2023 to March 2024 I'm ok with the delay, as it gives me more time to procrastinate if I need a new bike.... although new is nice, having difficulty justifying a new bike when the Alta does everything I need.

From eBay, I bought a clutch master cylinder and perch assembly from a 17-19 KTM350 EXC. Also found an Alta LHRB line on eBay. Works good. Works same as the stock Alta LHRB.

For those using the 3D printed repair, how is it holding up?

Hopefully they don't use a page from Harley Davidson playbook.....

I don’t have a picture readily handy of my bike. They look like standard handle bars. I you looked at my bike, you would assume they are ProTapers. Twisted Engineering | Good write up from @Phillip regarding the Fasst Flexx bars. I used them on a RMZ and eventually went back to standard bars on...

I've used fasst bars and they felt "heavy". Been using twisted engineering bars for years now It's another option when looking for bars that flex

I've had a charge issue which was intermittent....ended up being a wire was loose within outlet

Clutch for whiskey throttle situations would be handy .....

I went with steadystand for my boxvan. Work well, no complaints. My setup places first bike in backwards and second bike in forwards. This allows the bikes to be closer together for more room (generator, power washer, and the other stuff I probably don’t need to lug around)

Not mine, https://www.kijiji.ca/v-dirt-bikes-motocross/oakville-halton-region/alta-mxr-redshift/1578607035

I've changed silica packets without complete battery removal. In or out, that butyl is a pain to clean off.

That's it. I have one on the way. Thanks

yes...long one

Would anyone know the battery lower mounting bolt size? length x thread size? no idea how I lost it.... ugh...

Would be nice if it was 300mile range while pulling 10000lbs.... Can't wait until to have real world results on these.

You could look at arenacross layouts and adjust to fit

Start by hooking up MT and check humidity as a reference. (you will need MT to clear code) Replacement sealant (CRL Sunroof Butyl Sealant Tape / https://www.amazon.com/gp/product/B002CXGSKY/?tag=sce0f-20) Replacement silica packs (Mc Master-Carr# 2189K17) No need to flip bike. Remove lower...

Brass insert stripped when trying to remove the shrouds. Plan was to remove insert and replace with a crimp nut. After looking around, I found that I had some hex drive head nuts and decided to go that route instead. The hex drive head nuts screw in clockwise, so if the bolt ever gets stuck...

OEM length 67", from connection at reservoir to elbow of banjo connection You could also run a flexible line or rope through a route you want to use and then measure it's point A to point B