Need Help - FarDriver Controller Cutting Out on Jumps

[VINSANITY]

Hello,

I have a FarDriver ND961000 controller on a 96 volt conversion I built.

Unfortunately the controller cuts out after I hit the face of a jump under heavy load (it cuts out mid air) - after you come to a complete stop it resets and you can ride again.

All other riding is normal like hard acceleration or hard braking.

I’m stumped, I have two batteries and it’s the same problem on both.

It happens when I lower total power as well.

There is no error codes stored in the FarDriver controllers so no way to trouble shoot.

Any ideas would be appreciated.

 

[Philip]

Ouch! This must be some overcurrent protection. Scary! I remember @DonCox had that on landings, which is not as bad as on the face of the jump.

 

[VINSANITY]

I was able to get the controller tuned by a FarDriver specialist named Ryan Goodyear.

I bought the controller from E-Conic cycles which is a US based seller that offers post sale service, they connected me with Ryan.

The settings on FarDriver controllers are not intuitive and certain settings are very critical.

Nice controller in the end, very smooth power delivery.

 

[DonCox]

Thanks for the reference Philip, but Vinsanity and I have been talking for quite some time about this problem and others. My Far Driver Controller experience is limited. So Ryan Goodyear is a good answer. I corrected my problem on my Votol EM260S controller by replacing it. There must have been loose nuts and bolts inside of it.

 

[Philip]

I corrected my problem on my Votol EM260S controller by replacing it. There must have been loose nuts and bolts inside of it.