Search results

Really good film from F9 (he has good content) which in general goes into explanation of Harley. Agreed with @Judaslefourbe . HD is a piece of work and the attitude is a little too late. Doesnt help one of there investors also annoyed that HD went down the path of "EVs" and mobility than...

Wait...found it? KTM Radial Supermoto Brake Bracket | eBay

Here is the picture, googling doesnt do much as @Jon said.

They call the bolts Euro bolts(just like BMWs lol). Nice quality hardware and no loctite (yay). And the hardware for the fork is: BOLT, M8X25

Since most of the torx combi hardware was ordered from Bossard (bolt supplier). I used a company called Bolt Motorcycle Hardware

There are no wireless features that were part of production in the ACM (other than swapping your SD card for a wirless one to download ride data...)

Every pcba has a bootloader. So unless your playing with the parts...I dont see the rationalization of your post. (For the sake of the OP, you should take your comments to another post.)

Unfortunately no. They were middlish build MXRs which got modified into EXRs (since we were also launching EXRs)

The ACM contains the critical info of the bike ie(mileage, turn signal notifications and the VIN) - when mixing around parts, sometimes the firmware packages do not jive and create these situations. Boot570 is the old timing program we used before integrating it into multitool. Its quite a...

Good luck with boot-loaders. Everything that existed with boot-loaders has gone to a better place. Now you can argue, pretend or counter but every Alta employee involved with that area will say the same thing. Even with older inventory the likelyhood of getting something apart is possible, but...

Are the Knights of the Electric Iron Horse like the Knights who say NI!

Intrigued by the combi-bolt getting stuck on the boots...on the gear reduction side I take?

Apparently Diablo MX is open May 7th... Diablo MX Ranch

Yep thats it. See the link I sent you off of McMaster. M8x25.

Yes the Alta (especially the SM) is picky on loads. I think on the off board charger, not as bad. My main concern is the handshake. Once that handshake is confirmed it allows power from the station to then go to the charger. L1 or L2 would be ideal. L3 would be epic.

If its one of the x4 that hold to the Rear Bulkhead then: BOLT, M8X25 McMaster-Carr

@bluefxstc do you see any issues with the setup that I posted? I remember you posted about this before and linked the Tucson guy before...I also got this from the link for conversation sake.

The Hacksmith: Charge a One Wheel at any EV Charge Station Hacksmith was able to charge his Onewheel off of a L2 charging station with the setup above. Essentially replace the Alta charger with the Onewheel charger and make up the system in the link above (either swap out the 110V connector or...

It has no VIN number, interesting, it needs to be initialized with a VIN number so it can go through the next steps of associating firmware. Then it can associate a vehicle type. Also the loader tab as @Jayfox911 mentioned will explain more details.

Since it sounds like you hobbled together an Inverter, Motor, ACM, DCCP, Key switch, Battery and Display. Based on your picture you are not getting any coms with the ACM being initialized or Battery (BCU). Quite old firmware on those parts it seems. MT will let you know whats not...